Snowblower Forum : Snow Blower Forums - View Single Post - no sparky
Thread: no sparky
View Single Post
post #5 of Old 01-18-2017, 10:35 PM
skutflut
Senior Member
 
Join Date: Oct 2015
Location: Toronto, Canada
Posts: 1,425
Post Thanks / Like
Thanks (Given):
Thanks (Received):
Likes (Given):
Likes (Received):
Quote:
Originally Posted by choncy View Post
thanks for the prompt response, motorhead. yesterday, I took the shroud, flywheel, and assemblage off, cleaned what I could, checked gap on points, cleaned the rust off the pickup, cleaned the magnets, oiled the wiper for the points, checked all connections, and pulled the boot off the plug cable to derust the contact. I will doublecheck the wire from the shroud to make certain it isn't rubbed bare.

I was just thinking of something. pertaining to the ignition switch, when the switch is in the off position, does it complete the circuit to ground, thus preventing a starting condition? or does it function in some other fashion?


thanks in advance,
choncy
Maybe also replace the condenser as well if the engine is still apart and check the small ground wire coming from the coil as well for abrasions etc.

Work fascinates me.
I can watch somebody work for hours...
2008 Craftsman 944.528391 (It's a Husqvarna ST227P)
27", B&S 305cc 13.5 ft/lb Torque 9.5 hp

Last edited by skutflut; 01-18-2017 at 10:37 PM.
skutflut is offline  
 
 
For the best viewing experience please update your browser to Google Chrome