Snowblower Forum banner

Leftover part after removing carburetor.

2K views 9 replies 5 participants last post by  524SWE 
#1 ·
I removed my carburetor to clean the the jet. I placed all the screws and such on the fuel tank as I removed them. When I put it back together I was left with this part and I can't remember where it goes.
it measures 3/4 length by 1/4 I.D.






Thanks
Jason
 
See less See more
1
#2 ·
Maybe you should tell us engine?
 
#4 ·
It looks like a spacer to me. How much stuff did you take off to get to the carb? Maybe a sleeve or spacer for the starter??? MTD's have that Powermore engine and I know you end up taking lots of shrouding to get to the carb. Just random thoughts without knowing how much you dug into the engine.
 
#7 ·
looks like one of the spacers that go inside the shroud over the carb. there's a long and a short one, they fit inside the shroud, over the studs that the carb slides onto, two acorn nuts hold the carb on, the spacers and the acorn nuts work together so you don't over tighten the carb.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top