Old 03-08-2017, 11:56 PM Thread Starter
HELP Snowblower down! Throttle linkage setup Confusing.1650 B&S 30" Snow Thrower
This is my motor. I have scowered all avenues and cannot for the life of me find the correct linkage setup. I'll take a pic of what I have tomorrow, but leaning towards a missing cable. Anyone have a similar model would be FANTASTIC.
Have a lot of snow to move tomorrow
Old 03-09-2017, 12:26 AM
I have a 14.50 in the box still but I'm sure someone will have a answer before I can get to it after work tomorrow, if not I can pull the cover and take a few pics for you.
Sno-Tek Modded, 15"X-Track tires (Now has same X-Track tires but 13"x4" for better fit), 254cc engine LED light and hand warmers.
Snapper 6/22 sold but not forgotten. Was my first.
Ariens ST1027LE workhorse and going strong.
New 2017 Ariens Deluxe completely rebuilt after losing a fight with a forklift.
Old 03-09-2017, 12:37 AM Thread Starter
Old 03-09-2017, 12:47 AM Thread Starter
Old 03-09-2017, 10:14 AM
Old 03-09-2017, 10:34 AM Thread Starter
Old 03-09-2017, 11:33 AM
The manual is for Briggs Single OHV air cooled engines. What is the problem you have? The engines are all set up basically the same, they just bolt them to something. Is your problem with a remote throttle from the handlebar specific to the blower model?
Old 03-09-2017, 12:13 PM Thread Starter
Originally Posted by jtclays View Post
The link between the throttle lever and idle arm came undone. But I can't put it back together properly and I'm not sure if something is missing. It does idle high enough to use. Its purely a problem with the throttle linkages and springs under the gas tank
Old 03-20-2017, 02:42 PM
Originally Posted by DK5 View Post
On the governor plate under the tank, the engine speed control lever connects by a small rod to a movable plate where the governor spring anchors. When you move the throttle to low, the movable plate moves toward the governor lever, and reduces the spring tension on the governor spring. When you push the throttle lever to high, the movable plate moves away from the governor lever, and increases the spring tension on the governor spring.
You are going to have to post a few pictures of what the problem is. Create an account at photobucket, or one of the other free sites, post your pics there, then put links to the photobucket site in your message here, so we can go have a looksee.
Work fascinates me.
I can watch somebody work for hours...
2008 Craftsman 944.528391 (It's a Husqvarna ST227P)
27", B&S 305cc 13.5 ft/lb Torque 9.5 hp