Not sure if this is the correct place to ask, but I shall start here.
I have a Husqvarna ST230P with a bent Impeller. I ordered a new impeller, and the sheer pins, but I will confess I cannot figure out how to remove the Auger pulley.
I know it is threaded on, but not sure which direction I should be turning the "nut" on the pulley to remove it.
Has anyone else performed this feat?
Thanks in advance
I have a Husqvarna ST230P with a bent Impeller. I ordered a new impeller, and the sheer pins, but I will confess I cannot figure out how to remove the Auger pulley.
I know it is threaded on, but not sure which direction I should be turning the "nut" on the pulley to remove it.
Has anyone else performed this feat?
Thanks in advance