Snowblower Forum banner

Thoughts on Blower 2007 Troy bilt Snow King 30" 318cc 11HP 2 stage

4K views 7 replies 7 participants last post by  sscotsman 
#1 ·
#4 ·
I have the Troy-Bilt 2410 . . . mid-range machine. I got mine for $499, so it was a good budget machine.

The auger blades are lightweight, and I thought that they would easily bend, but so far they have not. The impeller design is poor and you will want/need the impeller modification.

The drive and impeller engaging mechanisms are cables rather than hard linkages, so they can have a lower life span.

I think Troy-Bilt (MTD) is out of their league making a 30" machine.
 
#5 ·
I've got a similar 28" 2007 MTD and it has handled about 12' of snow now for each of the past 10 years; but mine doesn't look as pretty as this one.

They failed to mention that this has "Heated Grips". The Single Lever "Joystick" is nice; but it does frost up occasionally (the hardest part has been understanding how it works!). Otherwise, a few belts, inner tubes, a friction wheel, and a couple cleanings of the Idle Restrictor Screw, and annual oil changes is about all it has really needed. I don't see why it won't last another 10 years or more. Keep it dry; keep it clean. I'd buy it again.

This 30" was priced at about $1050 in 2007. If the pictures represent its true condition close-up, it must still be worth at least half of that.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top