Snowblower Forum : Snow Blower Forums

Snowblower Forum : Snow Blower Forums (https://www.snowblowerforum.com/forum/)
-   Simplicity Snowblowers (https://www.snowblowerforum.com/forum/simplicity-snowblowers/)
-   -   simplicity 860se (https://www.snowblowerforum.com/forum/simplicity-snowblowers/110210-simplicity-860se.html)

blake03743 02-13-2017 12:09 PM

simplicity 860se
 
my 860 has a bad plug wire on it do i need to replace the whole coil? or just wire cant find any info on how to remove or get 2 the coil any help would be apperciated thanks

POWERSHIFT93 02-13-2017 12:42 PM

Are you sure the wire is shot??????? or is it just the end that hooks onto the plug?????? you can just get the replacement ends at your local friendly hood hardware store. or even some auto part stores. anyhoo, ALOHA from the Paradise City.:smiley-rpg027::smiley-rpg027::smiley-rpg027::smiley-rpg027::smiley-rpg027::smiley-rpg027:

blake03743 02-13-2017 01:04 PM

no the wire is shot in multiple places have been shocked by it have electrical tape on it now

blake03743 02-13-2017 01:21 PM

1 Attachment(s)
Can't see where it goes or what kind of job it is to get at it

JLawrence08648 02-13-2017 01:34 PM

It's attached, you have to replace the coil. However, what about slitting a rubber hose around it? Or take the end off, use shrink wrap tubing and then instead of slitting a hose, slide it on, then put new ends on.

RIT333 02-13-2017 02:35 PM

Their ideas will certainly be a lot easier, and much cheaper than replacing the coil. Worth a try...

skutflut 02-13-2017 03:07 PM

To get at the coil you would have to remove the recoil housing to get at the flywheel area, where the coil lives. You also have to remove as much of the engine shrouding as necessary to get the plug wire exposed so the new one can be routed the same way as the old one was.

Jo[email protected] 11-03-2017 06:55 PM

I've changed plug wires on other cdi engines, the wire threads onto a steel spike in the coil, the coil has a spiral spike that augers into the core of the wire. Outter insulation is epoxied to the coil. Snap the epoxy loose and unscrew it from the coil. Screw new plug wire on and secure with blob of epoxy.

43128 11-03-2017 07:04 PM

i would just use some heat shrink tubing.

Bluejoe 11-26-2017 08:35 AM

Liquid tape then shrink tape that should do it.


All times are GMT -4. The time now is 03:43 PM.

Powered by vBulletin® Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.

User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.

 
For the best viewing experience please update your browser to Google Chrome