Junior Member
|
LinkBack | Thread Tools |
Replace auger belt on Powersmart snowblower
I have a model #DB7651-24 Powersmart snowblower. It’s two years old. I cut the old belt off, and found a replacement. It’s the right size, but not identical to the old one. I removed the lower, and upper plastic belt guards. However, the two bolts that hold the drive, and auger pulleys are in the way. The bolt heads are so close together the space between doesn’t allow room for the new belt to pass through. Any suggestions would be much appreciated. Thanks!
Sponsored Links | |||
Advertisement |
|
«
Previous Thread
|
Next Thread
»
Thread Tools | |
Show Printable Version Show Printable Version
Email this Page Email this Page
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Toro 521 Belt Replacement | bilvihur | Toro Snowblowers | 5 | 02-04-2019 01:45 PM |
Snowblower pulls to side after replacing auger belt????? | alex30 | Snowblower Repairs and Maintenance Forum | 8 | 01-08-2019 07:26 AM |
Replaced auger belt now auger keeps spinning | bprintz | Snowblower Repairs and Maintenance Forum | 18 | 02-09-2018 12:15 AM |
new auger belt | jfacci7 | Craftsman Snowblowers | 6 | 03-07-2015 06:11 PM |
TRS-27 Auger Belt snapped AGAIN | Ryan | John Deere Snowblowers | 8 | 01-24-2015 03:00 PM |
Posting Rules | |