Snowblower Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 74 Results
  1. Ariens Snowblowers
    With the lack of snow this year my crusty 824 is getting some attention. Someone must have really worked this thing to wear out the bottom of the bucket. The spring for the brake shoe was very weak and not helping much with keeping the auger stopped. So I had a dirt bike kickstand spring laying...
  2. General Snowblower Discussion
    My Tecumseh 10HP finally "reached the end of its useful life" by tossing its con-rod out the side of the crankcase. Am repowering witha Predator/Pro-point 420cc. Attachment is a 36" 824004 broom with a cast aluminium bevel gearbox. I am concerned about the extra torque available damaging the...
  3. 03-fuel-drain-IMG_8481.jpg

    With the fuel line out, inspect the fuel being drained into a glass jar.
  4. 11-primer-line-IMG_8479.jpg

    This healthy primer line can be reused
  5. 10-line-fuel-IMG_8478.jpg

    This healthy fuel line can be reused.
  6. 09-carb-to-intake-gasket-IMG_8475.jpg

    Stens 485-140 Carburetor Gasket
  7. 08-jets-IMG_8470.jpg

    The ultrasonic does a fantastic job. No solvents. No cleanout wires to poke passageways.
  8. 06-exploded-IMG_8464.jpg

    The clean o-rings on the pilot jet will be grippy and may not allow it from properly seating. Use a bit of dish soap on the o-rings to seat the pilot jet back into the carb.
  9. 04-throttle-link-and-spring-IMG_8460.jpg

    Unlike older carbs with hooks and Z-bends in linkage, LCT linkage are removed while the carb is still in place. Close the throttle to lift up the link first, then carefully unhook the spring.
  10. 02-wiggle-lines-off-IMG_8457.jpg

    A personal hairdryer can warm up lines so they wiggle off by band, no tools.
  11. 01-remove-shield-shround-IMG_8456.jpg

    Blowers with LCT engines are by far the easiest of OHV's to get access to the carb: 4 bolts off the heat shield, 4 bolts off the heater box, one choke dial pulled up. No wires to remove.
  12. Snowblowers and Snowblower Parts for Sale
    I starting to accumulate more than desired amounts of ariens 10,000 series parts. No complete engines and no auger gears but let me know if there any other parts you may have interest in. H50/H60 engine. All parts are well loved. chutes Auger housing Gear box Auger shaft 1 auger / 1 auger with...
    $1 USD
  13. ariens-921029-throttle.jpg

    Ariens 921029 throttle assy
  14. Ariens Snowblowers
    Hello, Have a 6 yr old Ariens 921045 deluxe 24 blower that started to make a clanking noise when the wheels are engaged. I finished blowing, and noticed that if I engaged the blower but not the drive, it moved slowly in whatever direction I had it set to. I got to look at it today. Took the...
  15. Ariens-910018-friction-disc-09475300.jpg

    Ariens 910018 friction disc 09475300
  16. General Snowblower Discussion
    My experience with a snowblower is a cheap craftsman 2 stages (247.881731). It worked but I always wished I had a bit bigger machine doing my 2.5 car wide 150ft driveway. We averaged 30" of snow so it wasn't horrible enough for me to replace it. I moved to a new location and am in the market for...
  17. Snowblower Repairs and Maintenance Forum
    Hi All- I have a Deluxe 28 couple years old niw and light use during winters. Getting ready for possible snow and went to start using the electric start. Cranks hard but never catches. Visually everything looks ok- but there was half tank of fuel left in tank for the past year. I would like...
  18. Ariens Snowblowers
    I have an Ariens Deluxe 30 EFI, model 921049. The ECU is not lighting up. The battery is good (measuring 8.2V) and the fuse is good. Has anybody had an ECU go bad? Trying to rule everything out before I fork over $200 for a new ECU.
  19. General Snowblower Discussion
    Looking at getting a new (to me) snowblower this season and I have it narrowed downt o two models that I have found on FB marketplace and looking for some advice. Both machine are in like new condition. I have it between a Honda HSS1332ATD with 8 hours for $3,000 or an Ariens Professional 28...
  20. Ariens Snowblowers
    Hi everyone, I have an ariens blower model 926101 Serial 014189 and I cannot get the thing to fire up for the life of me. Heres how it happened. I received the snowblower last year and got it running by replacing sheer pins, carb, greasing everything up good, and it ran mostly fine all last...
1-20 of 74 Results
Top