Snowblower Forum banner
auger
1-10 of 10 Results
  1. Snowblower Repairs and Maintenance Forum
    New to this - have an ages old Toro 521 (38052) from my Grandma. Runs like a dream and have used it a few years after getting it. This past big storm in Chicagoland dumped a foot on us. (Which has since been followed by almost another 2 feet over the last 2 weeks) Starts fine, drives great...
  2. Snowblowers and Snowblower Parts Wanted
    Hi All, I have a pristine Simplicity sno-away 28" with 11hp motor that needs a left side auger. The sheer pin broke and before I knew it the auger had "welded" itself to the inner rod. Long story short after much banging and heating, I had to cut the auger into pieces to use a bearing puller to...
  3. Snowblower Repairs and Maintenance Forum
    I have a 2 stage powersmart snow thrower from Home Depot. Probably about 4 urs old. Hasn’t been used in a couple of years. Got it started up but while using, found that one auger is not spinning. Shear pins intact and no jam. Other auger spinning fine and throwing snow. What should I check next...
  4. Cub Cadet Snowblowers
    Hi, first timer poster. I have a situation I hope someone can help. My 31AM5BTR596 snowblower was working fine one day, then the next day, started as normal, drove fine but nothing but a terrible noise when I went to engage the impeller/auger. I checked the auger pins and found one missing, so I...
  5. Snowblower Repairs and Maintenance Forum
    Working on a bud's model 31as6gn3711 Troy Bilt 8526 blower. He had installed a 754-0430b (3/8 x 35'') cogged auger belt, which was too small to turn the auger. It appears that this model takes a 1/2 x 35'' auger belt. After installation, the belt (# 954-04050 / 754-04050) appears to be dragging...
  6. Snowblower Repairs and Maintenance Forum
    I have a Certified snow blower with an auger that's not spinning while under heavy load. About 2 years old, lightly used. Auger control cable is tight enough Belt seems ok and tight enough when activated. Manually turning over motor = impeller/ augur fully moves no problem. Sheer pins are all...
  7. General Snowblower Discussion
    It can't be possible, but... bought a new battery powered blower, expecting it to come in a box for me to assemble. Truck rolled up and a guy lifted out a fully assembled blower with the manual/parts in a box that had been re-taped. I tried to use it today in our first snow, and I have to say...
  8. Snapper Snowblowers
    I need the auger, part number 1739272 for my 10 year pld snapper Mid Frame Snow Thrower Model 130.887650 (Mfg. No. 1695734). If I can't find the complete auger, any hints on where to look for gears or used parts?
  9. Snowblower Repairs and Maintenance Forum
    Hello, I recently was gifted a Toro power throw 622 model #38062 serial 8904541 from a neighbor who moved to Florida. I went out to use it recently during a heavy, wet snowfall and it threw the first 3 feet of snow and then the auger stopped working. I walked it back into the shed and tried to...
  10. Snowblower Repairs and Maintenance Forum
    Hi i have a new-to-me husqvarna 1130sb-ls. There was a little bit of up and down play on one side of the auger shaft so I ended up replacing both side bearings. However there is still the same amount of play. I was wondering if this is normal? My old blower had bushings so the auger shaft sat...
1-10 of 10 Results
Top