A vane broke off the impeller in my trusty blower. Can't find a replacement online. Is there a less-traveled site where I might find this part? Is there an impeller for another blower that may work in the Troy Bilt model 42012?
I have a Certified snow blower with an auger that's not spinning while under heavy load.
About 2 years old, lightly used.
Auger control cable is tight enough
Belt seems ok and tight enough when activated.
Manually turning over motor = impeller/ augur fully moves no problem.
Sheer pins are all...
Hope all is well. I'm currently stuck at the moment and need some input. The snow blower has sat for a couple years so I drained the old fuel, cleaned the carb (replaced a couple years back), replaced the gas cap, and replaced the spark plug. The snow blower will start but stall 3...
Was just about to get started on replacing these belts on this snowblower and then discovered this forum. Was hoping to get some advice, tips or general cautions before I start to take it apart. Never worked on anything like this before so you can say I am a newbie for sure. Dont have a truck to...