Snowblower Forum banner

2000 toro 1332 power shift walks.

3K views 1 reply 2 participants last post by  UNDERTAKER 
#1 ·
I replaced both drive belts because they were showing signs of wear and ever since then I cannot adjust the cable to fully stop the machine.
3rd and 4th gear are ok but the machine '' walks'' in 1st and 2nd.
I rechecked the belt part numbers and they are the correct toro belts the only thing I can think of is the belt tensioner idler spring is weak and not fully releasing or I reinstalled the idler assembly wrong.Again I had no problems untill belt replacement.
Auger works as it should just the traction control.

Thanks in advance.Paul.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top