Snowblower Forum banner

I 722 - How to connect the spring return to the S lever

2K views 5 replies 3 participants last post by  Streamline 
#1 ·
#3 ·
Thanks for the speedy reply. I appreciate it very much.

Using a mirror I couldn't see any holes or obvious attachment points. Perhaps it is meant to merely float, but that seems a bit odd, especially because it doesn't then put any tension on the other end of the spring connected to the hole on the S lever.
 
#6 ·
JT,

Thanks for your help. That worked just fine with about a quarter twist. The L shaped end rests on the flat edge of the bracket, #44. In fact, I noticed some of the paint was gone where it had rested previously.

I appreciate your help. The weather in WI is below zero, so it probably won't snow for awhile. In any case, I'll be set.

Best wishes for the new year, JT.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top