Snowblower Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
579 Posts
Discussion Starter #1
Hello Toro owners, I have to replace a head gasket on the small block of my Toro CCR 3650 - I just need to know what I should torque the 4 head bolts too.
Thanks,
Tim
 

·
Registered
Joined
·
827 Posts
the Tecumseh Technicians Handbook on the repairs section of this site has the torque specs. Need to know the engine model number. Most head bolts are 16.5 ft-lbs on these size 4 cycle motors. I don't remember the 2 stroke motor spec.
 

·
Registered
Joined
·
579 Posts
Discussion Starter #3
the Tecumseh Technicians Handbook on the repairs section of this site has the torque specs. Need to know the engine model number. Most head bolts are 16.5 ft-lbs on these size 4 cycle motors. I don't remember the 2 stroke motor spec.
Thanks paulm12 for your response, the model # is 38517 but the engine is a 2 cycle Briggs & Stratton.
 

·
Registered
Joined
·
2,239 Posts
  • Like
Reactions: aldfam4

·
Registered
Joined
·
579 Posts
Discussion Starter #5
Thanks Grunt for taking the time to help me out.
Tim
 

·
Registered
Joined
·
2,239 Posts
Your welcome Tim, we are all here to learn and help each other. Good luck with the repairs.
 
  • Like
Reactions: jsup

·
Registered
Joined
·
1,549 Posts

·
Registered
Joined
·
2,239 Posts
Thanks for all you do sir.

:blush: Thanks for the kind words Del. You have always been an inspiration for me to help others as you have. I hope your son's shop is doing well.
 
  • Like
Reactions: aldfam4
1 - 8 of 8 Posts
Top