Snowblower Forum banner

1 - 1 of 1 Posts

7 Posts
Discussion Starter #1
Hello All,

I recently bought a TORO CCR 2450 single stage 2-stroke snowblower that had a locked up governor, so the engine went immediately to wide open throttle and did not come back down. I looked at the linkage, and the governor flap to carb linkage is all bent out of shape, I believe from the PO removing the carb and bending the crap out of it. I got it free, but now have a surging issue. The linkage will pop off with even the slightest pressure, so I know it is still not bent properly.

I'm hoping someone can post a picture of what the linkage is supposed to look like?

This is what it currently looks like:

1 - 1 of 1 Posts